Whats this wire for?

[AW3K]

hi

Behind the passanger side boot trim is a loom of wires terminating into a yellow connecting block ( | -- ) with its terminals looking like that.


Any one know what it's for as in my H reg 1.0L it's not connected to owt.


Thanks

AW3K

[whitey]

Boot Courtesy Light?!?

Should work when boot opens! if t doesnt work and the wire isnt plugged in then id be pretty certain that its that!!!!

[AW3K]

Nope :(

the boot light is the single red positive wire comming from the loom behind the pannel and the negative is connected to the switch, as it's a negative earth system.

If i remember correctly the wires that go into the yellow plug are 1 black in one side and 2 black with purple lines on them into the other side.


as seen here on topbuzz,

http://www.knighta.f9.co.uk/mods/euroclusters/twin_reverse/b_step7.jpg


Thanks

AW3K

[brian]

is it not for the rear wiper? have you got one? :?

[Ste_Nova]

rear wash wipe relay

yellow 2 pin is feed to motor

single black is rear demister

single red is boot light

[whitey]

Well there you go!

[AW3K]

Thanks m8

But whats the large multi block? black in colour with lots of wires in it for?

Thanks

AW3K

[Ste_Nova]

rear wash wipe relay

[ade]

or if yer referring to the one in the pic above with the wires running in to the black block - thats yer rear light cluster. (sorry of this is obvious but thats what the pic shows) - you can get the custer out by pushing it up and left I think...

Ade

[AW3K]

thanks for the replies.

the big block isn't shown in the pic above, i think it might be for the relay as mentioned.

AW3K

[mikeoxford]

thanks for the replies.

the big block isn't shown in the pic above, i think it might be for the relay as mentioned.

AW3K

sure is

no other "standard" wiring behind there