View Full Version : Tard question re width offset
Ok, so its quite early and my brain isnt up to speed yet....
Looking at selling my speedlines which as you are all aware are 6J and ET49
I am looking at some replacements which are 5.5J at ET38
My calculations say to me that the difference is a few mm, not a great deal at all.
Can someone confirm?lol
5mm more poke
17mm more strut clearance
Gaz1300SR
21-07-09, 09:07 AM
I had some 15" alpines on a Nova of mine years back, i think they were ET38 and scrubbed the arches over every bump. Can't remember if i had modded the arches or not......
How come you are selling your speedlines? Love those wheels.......
5mm more poke
17mm more strut clearance
Pretty much what Stuart's calculator says!
http://slindborg.hostei.com/wheel_offset/index.php
Pretty sure Speedlines are 6.5J?
Are they? I was sure they were 6?
Ah well- looks like I will be fine then in terms of inner/outer clearences.
And those TSW alpines were probably 7J ;)
EDIT - in fact if they were 6.5J the calculation is almost the same! Result!
Speedlines are 6.5!:thumb:
;)
Well - I should have known that! I have three sets (plus two spares) too!
:tard:
;)
Well - I should have known that! I have three sets (plus two spares) too!
:tard:
lollollollol No excuses then :p
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.