removing suspension etc

[let_nova]

is it possible to unbolt the tie bars from the x member, bottom arms from the chassis, trackrods and drop the suspension down and remove all that still attached together.:confused:

[16v Nova Kev]

should be but what about the cvs

[let_nova]

was thinking just undo the castle nut... but would there be enough flex in the antiroll bar to pull it out hub?

[16v Nova Kev]

i would do trackrods/bottom arm bolts /tie bar then 13mm strut tops in that order and odviosly calipers and castle nuts

[Mark Sparks]

For the cv joints unclip the cv boot and slide it up the shaft, wipe all the grease of and then you will be able to see a C-clip use C-clip liers to prise it apart and pull the shaft out of the cv joint do this on a full lock. easy as that. Hope this helps

[let_nova]

cheers lads will hopefully save a bit of time.