Twin 45s someone please help

[Rob]

Right i,m in the process of fitting these to mine and have run into a slight problem,theres a connecter coming out of the SBD inlet manifold next to the altenator bracket mounting and i,m not sure where to connect it to :confused:

http://i143.photobucket.com/albums/r121/novafusion69/DSC02654.jpg

on the standard manifold this pipe comes out of here
http://i143.photobucket.com/albums/r121/novafusion69/DSC02653.jpg

and goes underneath joining under the throttle body then another pip comes out of here
http://i143.photobucket.com/albums/r121/novafusion69/DSC02652.jpg

[Graeme]

From that pipe fitting straight to the tee piece in the top header tank hose

[Rob]

so do i need to put a t-piece into this pipe and connect it to the outlet on the inlet manifold

http://i143.photobucket.com/albums/r121/novafusion69/DSC02655.jpg

[Graeme]

Did you not run a tee piece before? Where did the pipe on the factory inlet go to previously?

[Rob]

no i didnt and its been that long since i stipped it i carnt remember where it went to lol

[Graeme]

I've only ever seen them blanked off or running in to a tee in the pipe you point to, can't imagine how it was previously done as it is needed to bleed the system of air, this is why I don't advise blanking it off

[Rob]

i,ll have a look in the bay see if can see where the old pipe went to,and if no look ill branch it in to a t-piece on the header tank hose

[Graeme]

It must of gone into the coolant system somewhere, good luck

[Geordie-Chris]

As already said, T it into the header tank. Does your alternator clear the carbs??

[Rob]

As already said, T it into the header tank. Does your alternator clear the carbs??

i,m going to try and find where the old pipe went to first then t-piece it into the header tank hose and i havent fitted the bracket yet but it looks like the alternator will clear with the standard bracket.

And graeme cheers i,ll update this as and when i get round to it

[Graeme]

No problem