Log in

View Full Version : Whole Xe Setup For Nova!!


ST-eater
30-06-09, 02:06 AM
Hi All...

After A Complete Set Up To Turn A 1.2 Carb Nova Into An Xe, Need Shafts, Engine, Brakes, Loom, Fuel Pump Etc... Basically The Works Other Than Suspension...

I Need It All To Be Running Fine, And In Good Condition...

Prefer The Box To Be An F20 Or Wide Ratio F16 As It Will Be A Daily Driver, And My F16cw Is Driving Me Nuts Atm.

Let Me Know What You Have, Location And Prices... Cheers All
Mint FRST
30-06-09, 07:37 AM
I have a complete engine/ancilaries and gearbox here...

http://www.pngclub.com/forum/showthread.php?t=113130
projctnova
30-06-09, 08:31 AM
i have a full set of engine mounts brand new and also rear disk conversion plates.

pm me if interested
matt_vaughan
30-06-09, 10:09 AM
Whereabouts are you mate. I know of a lad selling a complete setup in West Yorkshire
chrisnovaturbo
30-06-09, 01:43 PM
ive got a brand new set of m-tech shafts 80 pound posted
328i
30-06-09, 05:31 PM
got 2ltr calipers ,pads and drilled and grooved discs here mate
ST-eater
30-06-09, 05:49 PM
Whereabouts are you mate. I know of a lad selling a complete setup in West Yorkshire

Im miles from there but willing to travel for the bits depending on what he has...

Cutting a long story short its going in a fiat, so rear disks wont be needed... basically im after the complete front set up for the nova.. and everything will be adapted as needed.
ST-eater
30-06-09, 05:50 PM
got 2ltr calipers ,pads and drilled and grooved discs here mate

How much you looking for, are the pistons and bleed nipples free or seized?
ST-eater
30-06-09, 05:53 PM
I have a complete engine/ancilaries and gearbox here...

http://www.pngclub.com/forum/showthread.php?t=113130

Whats the best price on the lot engine wise, is it complete and running? and what code ecu is it? How long since it was last ran?
Mint FRST
30-06-09, 06:08 PM
Whats the best price on the lot engine wise, is it complete and running? and what code ecu is it? How long since it was last ran?

Price as stated in my thread which for engine C/W all ancilaries i.e. alternator, manifold, loom, gearbox etc is a bargain.

Will confirm ECU code later...

Engine has ran for 12months. However it is on a proper engine stand in my garage and still has oil in it. I regulary turn it over by hand at the crank...

I too have ATE calipers and disc's which could be part of the deal
ST-eater
01-07-09, 12:12 PM
Price as stated in my thread which for engine C/W all ancilaries i.e. alternator, manifold, loom, gearbox etc is a bargain.

Will confirm ECU code later...

Engine has ran for 12months. However it is on a proper engine stand in my garage and still has oil in it. I regulary turn it over by hand at the crank...

I too have ATE calipers and disc's which could be part of the deal



Cheers, are the disks groved or just the normal flat & vented?

Have you any shafts?