View Full Version : XE rear mount assembled pics
Find Simps post in Articles mate :)
Basically you just cut a gap in each side of the mount, fit 2 spacers one side, and the other spacer on the other side.
Then bolt it up
skidmarkz
27-06-09, 09:58 PM
as adam says fit the 2 spacers gearbox side, and the single spacer drivers side,
i fitted mine then welded them into place :)
http://www.pngclub.com/forum/showthread.php?t=90103
What do i do if ive only got 2 spacers?
Buy another one?
Can you buy just one seperatly?
djbrowney
28-06-09, 05:02 PM
either make one your self or just take it down your local engineer company, im sure they will make one for peanuts !!!
either make one your self
Good thinking lol can tell im still hungover lol
You need the metal tube for the 3rd bolt too if you dont already have it.
You could use just 2 and not use the 3rd hole. Some kits only have 2 anyway, whats it going to be used for?
loggyboy
29-06-09, 07:57 PM
id always recommend using all 3 i sheered 2 bolts on mine as they worked loose. (better advice would be to make sure u fold the lock tabs down on the washers!)
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.