Smaller Than 49 Offset Alloys In 15"

[Chris S]

Need Some Alloys Around 25-40 Offset, Not Bothered On Colour, Condition, Make Ect So Long As There Straight. In 15" To Fit Over V6 Brakes.
Need 2. Will Buy A Set If Needed

[stafford]

i have v6 on with vectra wheels, you should pick a set up cheap

http://i145.photobucket.com/albums/r240/staffordk427wcp/Myxecorsa.jpg

[Mazz]

4 stud or 5 stud?
if your 5 stud, you can use some Omega, Carlton etc wheels as they use a lower offset - ET38 iirc
if you 4 stud, also i'm sure the veedub boys run lower offsets too, so it might be worth nosing around there forums for some cheapy wheels.

[Chris S]

Ye Thanks. Its Just For A Set Of Wider Tyres So They Dont Rub My Coilovers

[JordyzNova]

go for 15" steels you can get them in 4 and 5 stud

[Chris S]

Will They Fit A 225 Tyre Though?

[stafford]

i have spax adjustable coil overs on the front, 4 stud vectra wheels with 195/45r15 tyres by the way, when i bolt it altogether the tyre did rub on the nuts to the springs (the ones that move lower and higher) but i wanted the car at that height, but i noticed the camber angle of the wheel was alot, so i went and got camber angle bolts £33 from demon tweeks. when i went to get the bolts in and set, the camber angle was at 3 degree's when standard it should be at half a degree and when the bolts was in we got it to 1 degree, the bolts wont go far enough but the camber angle bolt brought the wheel a way from touching.
hope this helps

stafford

[Chris S]

Were Abouts On Tweeks Site?? Cant Find Em?