View Full Version : Front Lower Crossmember
boffer8
15-06-09, 12:15 AM
Hi, i am having problems with my front cross member cracking, bending and twisting with the supension arms having no give even though it has been seem welded and strengthened, i think i recall seeing someone cutting it out and replacing it with a piece of box sectiuon steel but cannot find it on here, does anyone know where the piccies are or have any advice on doing this?
cheers
ben
Paul did this on his turbo. Few other people have done it but cant think who.
boffer8
15-06-09, 08:20 PM
does anyone have any pics of it?
Search his wip mate. Check out some other peoples too. Usualy done on high spec lets and the like.
Hi, I did do this on my turbo, and found out that a 2x2 box section is not man enough.
I have added another one in front of it so its effectively 4x2 but with like a 10mm wall in the middle (stitched the two box sections together)
Search for my WIP think its on about page 3.
http://www.pngclub.com/forum/showthread.php?t=88650&page=29
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.