c20xe arp mains?

[yayoboy]

do you tighten the studs by hand, then torque the nut up? cheers

[djbrowney]

there should be an alan key hole in the end to do the studs up mate

[yayoboy]

yes there is m8 but just wondering if you have to torque the studs, then the nut. im sure i was told to just put the studs in by hand then torque the nut? what you think?

[djbrowney]

you dont need to torque the stud but make sure you use some locktite mate

[yayoboy]

so with the stud then, wind it fully in till it stops yeah?

[djbrowney]

yes mate

[novaxe235]

wind the stud in by hand (hand tight) make sure you lube the thread with the arp moly grease then put your nut on and tourque down (you can use blue locktite on the stud if you want i do but not a must):thumb: