Matt
13-06-09, 12:24 PM
Fitted my new wheel yesterday and it wasn't on quite straight so have whipped it off again today. I'm just trying to refit it but can't quite get the nut to tighten onto the shaft as it doesn't seem to be sticking through enough. I can get the nut to go on without the washer, but obviously I need the washer!
It seems the the shaft has been knocked back a mm or 2 and just isn't sticking through quite far enough for me to tighten the boss back on again. Is there a way I can adjust this and slide it back through a bit further?
Cheers.
It seems the the shaft has been knocked back a mm or 2 and just isn't sticking through quite far enough for me to tighten the boss back on again. Is there a way I can adjust this and slide it back through a bit further?
Cheers.