Ric 16v
07-02-03, 06:12 PM
I have recently changed my 1.2 engine for a 1.4 sr one, the 1.2 was single point injection and the sr is a carb the sr engine is run off the 1.2 loom and when I come to start it in the morning It starts but doesn't idle so I have to rev it to about 2000 revs but it just cuts out, I have to do this about 4 times untill it starts runing properly and I can set off, if I put a full 1.4 sr wiring loom in would it cure this problem or would it be the same? the engine runs sweet as a nut, but it's starting it which is realy pissing me off, HELP PLEASE