intercooler needed

[nova 1.6 gsi]

.

[craig green]

What for?

I have a BMW front mount going cheap... Might be of use.

pics in a bit.

[nova 1.6 gsi]

im wanting one to fit length of number plate so i can cut a mouth out for cooler to fit

[Johnny A]

Got a 2wd cossie unit here if interested

[nova 1.6 gsi]

do you av any pics mate

[craig green]

im wanting one to fit length of number plate so i can cut a mouth out for cooler to fit

The one I have is ideal...

http://i30.photobucket.com/albums/c323/turbocraig/bits4sale/Novabits4sale079.jpg

[nova 1.6 gsi]

how big are holes mate as im running 3" boost pipes

[craig green]

Less than 3"

[nova 1.6 gsi]

cheers for the offer anyway mate it was worth a try as i wud av had it if it was 3"

[Johnny A]

Like this:
http://www.rscosworthbreakers.co.uk/partimages/DSC_2132.JPG
without the section of plastic trim.

[Mike]

I have a massive twin pass stainless steel one thats brand new, with 3" inlet/outlet both on same side

[nova 1.6 gsi]

iv got a skyline 1 but its a bit too wide i wanted boost pipes to go down each side of rad if any1 has any ideas to get it to fit id be most greatfull cheers jon.

[ste porter]

running 3 inch pipes and a cooler the size of a pencil case?
your either not going to be running much power and the 3 inch is over kill or your running alot of power to need 3 inch and in which case the extra heat generated by the mass increase in boost to fill them pipes will soon over welm and heat soak a cooler that size trust me!

[nova 1.6 gsi]

i think its an 18 row cooler off GTIR one cus its big full depth of bumper neally and full width of number plate and a bit more, im hoping to be running 350 plus through cooler i was told i needed 1 that big it wasnt that i wanted it mate i wanted to hide it really what u think ste? msg bk cheers and thanks for ppls advice and offers much appriciated.

[Stuart]

for the record folks, offering to sell someone something using a pic from ebay, and quite probably buying the item in the pic from ebay to sell onto someone on here at a fisting of a rate isnt necessarily on.

I'm watching you ;)

[ste porter]

for starters im using a gsi rad centralised and my 2 inch pipes touch both the rad and chassis so 3 inch will be squashed i would imagine so you would be aswell with 2inch as what you would squashed 3 inch not to mention the potential for chafing

secondly i was running 7psi boost at pvs ok i may have alot of internal mods but most of them are fail safes and strengthening i.e steel rods ectto insure that when i do get sorted and raise the boost levels it will last . but im only running an ebay job for the time beeing and the results speak for them self realy have a look at the pics of mine and ask on here how i got on im sure mike can tell you

if you want any more advice on anything specific ect pm me mate im always pleased to help