pattern body panels

[torquey]

Has any one else had problems trying to get the above looking good? Got a bonnet it lines up one side good but the other is miles out. Iam sure its too short on one side. not happy.:mad:

[Pistol Pete]

Hammer and brute force FTW. Have a gander at my WIP thread in my sig. I had major fitment problems. To the point where i cut off my nice new front panel and bought a new one! Bit of hammer action, and jiggery pokery, all good!

[lee-loon]

Very common with pattern parts,ive used panels from Toys 'R' Us before and to be honest its not only the fit that is poor its the quality of the steel.

[Pillar]

Has any one else had problems trying to get the above looking good? Got a bonnet it lines up one side good but the other is miles out. Iam sure its too short on one side. not happy.:mad: where are you? i got a spare bonnet:thumb:

[brainsnova]

use a measure tape and check and if its miles out use it for welding practice.