View Full Version : need help with 2.0 8v loom
silvertornado_sr
24-05-09, 06:27 PM
brought the engine without loom so trying to connect all the connectors up any help???
thanks mark :)
saloonwoody
24-05-09, 08:10 PM
did you get another 2l loom ?
craig green
24-05-09, 10:24 PM
Easiest to lie the injector loom in place & that should start to show how far each connector needs to reach, ie AFM, CTS,temp gauge, dizzy hall sensor, oil temp, TPS & ICV etc. Usually the plugs only fit the relevant sensor (in most cases) though some 2 pin connectors can be same & muddled up.
silvertornado_sr
27-05-09, 04:36 PM
theres 3 wires gear box end green black and red with no plug any help???
got ruff idea where the rest go but these also which wires need to be connected to the old wiring loom
thanks mark
silvertornado_sr
27-05-09, 04:39 PM
also 4 pipes on fuel rail?? any help???
craig green
28-05-09, 10:38 AM
Pics...
silvertornado_sr
28-05-09, 06:30 PM
http://i15.photobucket.com/albums/a393/silvertornado/Photo0081.jpg
http://i15.photobucket.com/albums/a393/silvertornado/Photo0082.jpg
http://i15.photobucket.com/albums/a393/silvertornado/Photo0083.jpg
silvertornado_sr
28-05-09, 06:30 PM
on the wiring the red one doesn't go anywhere ?
help
silvertornado_sr
28-05-09, 06:32 PM
also added pics of fuel pipes :S need help which is in and out and what the other pipes are :s
red is to perm live, black to swithced live green to rev counter. and read the how to guide ffs!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.