View Full Version : can somone help me
k925franny
20-05-09, 09:33 PM
right i have put an xe in my nova and i have had my calipers of the front end for about 6 months and now i cannot get the brakes to work after going through 3l of fluid and alot of time trying to bleed the brakes up but i still cant get them to work the peddal goes straight to the floor so does that mean there is no resistance in the peddal
if the pedal hits the floor, the master cylinder could be knackered, or there is serious airlocks in the pipes
what state are the rear brakes in????
do you have an easy bleed??
have the calipers been removed recently?? its been known for people to fit them upside down
this should be in mech.
k925franny
20-05-09, 10:11 PM
blead the brakes up there are no air locks but i was finking i had the brakes of but i had the line clamped and i fink i could of split the lines so im guna replace them with braided lines and change the master cylinder
sulphur
20-05-09, 10:19 PM
Check your calipers are on the right way up as said, I had the same problem not long ago. lol
gaznovalet
21-05-09, 12:15 AM
you got the vaccum pipe connected up? from servo to inlet manifold.
my cash is on master cylinder.
have you reconnected the linkage bit at the back of the servo?
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.