PDA

View Full Version : Wiring loom



xe_nova9
04-05-09, 10:00 PM
HOW TO* Wire a 2ltr Into A NovaDepending on what nova model you start with will depend on how easy this will be. Vauxhalls normal setup is to have 2 main looms. One for all the lights, interior, radiator, fans etc and one for the engine. These 2 looms are then connected by a few plugs. Some nova models are like this and some aren't like the SRi & SPi where these 2 looms are integral. If you have an integral loom it is worth spending the time cutting it all out. It will leave you with half dozen permanent & ignition lives and earths but this is not a bad thing as they can be used for guages etc later on.

I have a j reg mk sr currently with a 14nv carb engine, with regards to wiring with a 2 litre could someone tell me whether that model has 2 seperate looms or are the joined together? If they are joined together would it be easier to use a loom from a 1.2 injection nova(assuming that has 2 seperate looms) I also have then join that to the xe loom?could I have your suggestions as to what is the best route to go down, also where is the point you can tell there is one integral loom or two seperate ones? Thanks

Pistol Pete
04-05-09, 10:31 PM
Only car with intergrated loom is the SRi. I had this ball ache. Just got another loom from a scrappy.

Oh, and this should probably be posted in the tech section. Hey ho.

Nobby
04-05-09, 10:32 PM
Mate you need to speak Lee hes seem to know there stuff with the old looms.
I think you use the xe engine loom ie all sensors etc and the nova starter altenator looms etc and then join the internal wires ecu, fuel pump etc etc

The Simps
04-05-09, 10:38 PM
if its a carb engine it will more than certainly be a single loom as it won't have an engine loom as such.

You'll have the loom for the starter, alternator etc which you keep. The only other sensor you'll have going to the engine (from memory) is to the thermostat housing which is part of the car loom.

Hope this helps, and someone please correct me if its wrong.

xe_nova9
04-05-09, 10:44 PM
Ok thanks, i'm not really sure what I have to use, im guessing that I use the loom I have for the 1.2, i say loom I jus mean the loom for the inside of the car interior lights etc then attach the xe engine loom into it, thats the theory anyway, have you got 'lees' details so i could PM him? Thanks

Nobby
04-05-09, 10:51 PM
have you got 'lees' details so i could PM him? Thanks

Try that mate -http://www.pngclub.com/forum/member.php?u=11488

Hope Lee dont mind he is admin though lol:D

The Simps
04-05-09, 10:54 PM
Its really easy with the carb loom purely because there's less wires to faff around with.

xe_nova9
04-05-09, 11:02 PM
Thanks for your feedback, I've e-mailed lee so see if he can help. You should all come round and do it for me once the engines in lol :thumb:

The Simps
04-05-09, 11:05 PM
where do you live?

xe_nova9
04-05-09, 11:07 PM
Tadley, Near Basingstoke, miles away from norwich i think lol dont think anyone on here lives close to me

The Simps
04-05-09, 11:11 PM
How cool would it be if you bought the car to billing with your xe and all your bits in the boot and we do a "live" conversion! lol

xe_nova9
04-05-09, 11:16 PM
Lol that would be good but got few too many bits to fit in the boot lol thanks for your help mate :thumb:

The Simps
04-05-09, 11:24 PM
happy to help.

MK999
04-05-09, 11:33 PM
Tadley, Near Basingstoke, miles away from norwich i think lol dont think anyone on here lives close to me

I used to race R/C cars in Tadley :thumb: Would have thought it was closer to newbury though :confused: Unless there's another tadley lol Anyways, not that far from me, know what you mean though it seems very quiet in this area :(

Live conversion would be awesome lol I think you'd get 8 different opinions on everything though lol

tom_beverley
04-05-09, 11:37 PM
Sell me the SR ignition loom please :thumb:

Lee
04-05-09, 11:39 PM
lol, i used to live in newbury, and now im in Bristol. Aint that typical!

MK999
04-05-09, 11:48 PM
I always thought "nr chipping 'sod'bury" was a pisstake, but it is in fact a real place, far too far away to wire up my 1.6 too now lol

The Simps
04-05-09, 11:55 PM
Live conversion would be awesome lol I think you'd get 8 different opinions on everything though lol


There's a jooke there....

How many PNG'ers does it take to do an XE conversion? lol

MK999
05-05-09, 12:00 AM
I can just see a mass of 20 people surrounding a car and it being like a dodgy bomb disposal scene from a cheap movie "no the red one" "green" "definitely blue" and some tit running around at the back going "pink, purple, yellow, orange" to make it sound like 6 people

Leeboo
05-05-09, 12:35 AM
"No you hold the hub while I beat the tie bar to remove the bottom ball joint!"

"Hurry up and disconnect the speedo cable, its taking the weight of the engine!"

"Move that passenger side shaft so i can get the gearbox up past it!"

"Battery connected? Yes! Ok - ...Ah deh deh deh deh deh deh deh.....A deh deh deh deh deh deh.......baw baw baw baw.... YES!!!!!"

Some common expressions lol

The Simps
05-05-09, 01:15 AM
"Where's my hobnob with this cuppa RJ?"

MK999
05-05-09, 03:05 AM
"Where's my hobnob with this cuppa RJ?"
Dar? lol My first rep was from him and simply said "hobnobs rule!!!!" lol