PDA

View Full Version : is this ok?


Asa-James
21-04-09, 10:28 PM
whilst doing a bit of undersealing on the cav i noticed this...
http://i87.photobucket.com/albums/k155/asa_037/IMGP0247.jpg
http://i87.photobucket.com/albums/k155/asa_037/IMGP0252.jpg

it looks to be nothing structeral, just a piece of box section between the rear chassis legs. is it worth plating? or just leave and see what the MOTer says?
General Baxter
21-04-09, 10:30 PM
fill it with sealer then stonechip lol
burgo
21-04-09, 10:37 PM
better off doing it now instead of letting it get worse
mikey14sr
22-04-09, 09:53 AM
Plate it up, my opinion is if there's a box section there, it's there for a reason!

With that as it is should the car get rear-ended (shut it pervs!) it's going to fold up a lot easier than it would.
novaguy08
22-04-09, 02:37 PM
looks like that is the box section that runs off to the nearside of the car. Agreed with everyone here, box section is usually structural, get it cleaned up & weld something in there.
paul james
22-04-09, 03:20 PM
Get it welded, shouldn't cost much or take long to do at all, since its under the car it wont need to look pretty.

Oh and it looks like you could do with a new exhaust rubber mount, that ones split.
Asa-James
22-04-09, 07:34 PM
Oh and it looks like you could do with a new exhaust rubber mount, that ones split.

its just a bulky bit at the bottom, its all gooood:)


and ta for the input fella's, the mot's due in a coupla months, so i'll send it to my uncles garage and get him to weld it before he tests it

and about the rear end comment (ooh err!) i've seen what a cav can take from behind, my old fellas last one was shunted at approx 50mph... not nice even in a good car!