c20xe coil with amp on bracket

[ST-eater]

After the above, can collect this evening with cash in local area (upto 60mile from LE9 area)

Needs to be working and complete with the bottom part where the c20xe 4pin connector fits off the loom....

Cheers

[Mike]

I have one here that i was using on my E16, cyclindrical coil with amp & a stainless steel mirror polished cover on it.

[ST-eater]

I have one here that i was using on my E16, cyclindrical coil with amp & a stainless steel mirror polished cover on it.

Where abouts are you? not 100% sure it will work on the 2.0, have you got a multi meter to find out? Need a resistance between 0.2 to 0.34ohms over the primary winding (from one pin on the coil to the other) and 7.2 to 8.2ohms on the secondary side (on pin to the centre part where the HT lead comes out).

If you could let me know the readings id appreciate it, cheers :)

[Mike]

Where abouts are you? not 100% sure it will work on the 2.0, have you got a multi meter to find out? Need a resistance between 0.2 to 0.34ohms over the primary winding (from one pin on the coil to the other) and 7.2 to 8.2ohms on the secondary side (on pin to the centre part where the HT lead comes out).

If you could let me know the readings id appreciate it, cheers :)

Havent got a multi meter to hand, but it was taken from a 20XE equipped Calibra chap.

Im located in the West Midlands, Wolverhampton.

[cemex]

got one here aswell