PDA

View Full Version : SR gauge pod printed curcuit


novaguy08
14-04-09, 05:37 PM
Right guys, i need a new printed circuit for my SR gauge pod, its a 4 gauge one (the one with the oil light and bat light insted of the gauges) must be in good nick. knackered the one on mine by shorting it out against the bulkhead and the solder repair i have done is intermittant.
Need price posted please. PM me and ill let you know if its the right price. Not wanting to buy a whole pod unless you plan on pretty much give it to me and if you are then i would want a GSI 6 gauge one and the oil pressure switch :D but again DONT PM ME IF YOU WANT TO SELL ME A £30 POD UNLESS YOUR PRETTY MUCH GIVING IT TO ME!! (not a hint!) MUST BE A 4 GAUGE 14 PIN (mk2) ONE NOT A 6 GAUGE ONE OR A 12 PIN ONE:thumb: :thumb:
xe Dan
14-04-09, 05:47 PM
ive got a set of gsi dials that seem to over read for £10 posted if they are any good to u ?
novaguy08
14-04-09, 06:51 PM
deffo 14 pin & fully working (even if it does over read) ill have a ponder and get back to you will probs take them on friday
xe Dan
14-04-09, 07:16 PM
deffo 14 pin mate and 100% working as they came out of my car
novaguy08
14-04-09, 09:53 PM
lurvley :D
If you include the 2 pin oil pressure switch then ill have a serious think on it :D
when you say reads high, how much by?
xe Dan
15-04-09, 10:32 AM
temp reads about half when cold petrol about half when empty and the other two aint that bad i think and wot u mean by oil pressure switch ???
novaguy08
15-04-09, 10:57 AM
the pressure sender i means, bit that goes into the oil pump.
has it got the oil pressure gauge and voltmeter then?
xe Dan
15-04-09, 11:33 AM
yeah has got volt meter and oil pressure gauges i havent got the pressure sender all ive got is the dials
novaguy08
15-04-09, 12:43 PM
righto will let you know if no-one can get my the circuit