PIC REQUEST Big block engine mount.

[Steve]

Anyone got a good pic of the drivers side mount on a 2.0?

Not sure if my mount is bent or its the engine thats not sitting straight.

If you've got one where it mounts the rubber that would be even better.

:thumb:

[valvercorsa]

post yours up and i tell you :)

you fitted spacer on back mount mate?

[Steve]

It all because of the front ender it had, it was all fine before as it was spaced out right but after changing the rear mount the front doesnt look right.

Im pretty sure it is bent but just wanted to check. I assume it should be a perfect 90 degree angle? Mine aint lol

[Pistol Pete]

Poor pic...but yes 90 degree angles...

You can also just make out that the top hole was used.

http://img.photobucket.com/albums/v310/Pete_58/Nova/IMGP0707.jpg

[Steve]

Cheers pete, mines curving away from the rubber mount a bit.

Gonna try and straighten it out.. again. lol

[BIGS]

http://i241.photobucket.com/albums/ff314/b17ova/2ltr/newnova008-1.jpg

http://i241.photobucket.com/albums/ff314/b17ova/2ltr/newnova006-1.jpg