Wanted...

[ST-eater]

Looking for a few more parts for my c20xe conversion....

oil cooler/pipes

External fuel pump + 8mm lines (engine's running @ 3bar)

digi dash

Inner CV joint to fit 22 spline shaft, (running an f16 box)
The bit that connects inbetween the box and the shaft itself. (as ive lost some bearingsm not sure what the cup fitment is for, so if anyone could clear it up as to wether its a astra or cavi one)

Can you PM me prices, ta

[ST-eater]

Also looking for a bottom single V pulley

[Mint FRST]

Hav a single pulley....

[ST-eater]

how much you looking for posted/collected? Do you have the bolts to fit by any chance?

[Mint FRST]

how much you looking for posted/collected? Do you have the bolts to fit by any chance?

No bolts, make me an offer. Its been turned down from a two grove Astra item too...

[jord77]

also so have oil cooler and v pully here :)

[ST-eater]

No bolts, make me an offer. Its been turned down from a two grove Astra item too...

The one on at the min is a double astra one, and i need a single, but not really sure what their worth. Let me know, posted :)

[ST-eater]

also so have oil cooler and v pully here :)

How much each, posted?

[ST-eater]

Also looking for a top strut brace to fit around the 2.0 16v

[jord77]

i see you want a single v pully mate i have the twin one

looking 30 posted for v pully


20 posted oil cooler

[ST-eater]

i see you want a single v pully mate i have the twin one

looking 30 posted for v pully


20 posted oil cooler

is the cooler on its own or with the pipe work?

[16v Nova Kev]

you have a pm st

[16v Nova Kev]

clear you inbox mate

[jord77]

i have pipe work with it just a couple of fins bent but it came off my nova 6 months ago so it fine

[jord77]

hi mate this is the pully i have

http://file046b.bebo.com/20/large/2009/02/17/14/69058872a10122760061l.jpg

[ST-eater]

hi mate this is the pully i have

http://file046b.bebo.com/20/large/2009/02/17/14/69058872a10122760061l.jpg

Interested in the cooler + pipework, il get back to you on the pully as its what im after but getting a quote to have mine machined if possible, or a cheaper option as im throwing money all over the shop at the min