err.. whoops

[jimbob-mcgrew]

i rushed into it a bit, and neglected to read the haynes properly.
i undid my head bolts in the order that your supposed to tighten them instead of the opposite order like your supposed to, bearing in mind i was gentle, and cracked them all off bit by bit 4 times round, before procceding to turn them quarter turn at a time.

will it be ok or is there a chance ive fcuked the head ?

[tom reid]

Head will be fine, stop worrying,lol

[ade]

YOU ARE BAD!

TBH dont think it matters as you took your time - plus dont you skim the head anyway?

[draper]

oh noes, scrap it

in fact to be sure id set fire to it then piss on it to put it out

[Sloth]

lmao, been at the beer draper? jim, its fine dude, get it skimmed and put the whiskey away when readin haynes...

[jimbob-mcgrew]

heads off a 1200 carb. needs all its meat on it - its going on a 1400 block.
yeh maybe i should lay off the whisky for a bit.

[Sloth]

ahhh higher cr, id give it a very light clean and a tiny skim

[jimbob-mcgrew]

i used the rocker cover as an ashtray and stubbed out a few butts lol

[dj_wudgey]

i used the rocker cover as an ashtray and stubbed out a few butts lol
pmsl!!