c20let @ 1 bar what power to expect?

[alan b]

getting my car dyno'd next week or two running 1 bar walbro pump, phse2 chips, 3.5 bar regulator, bleed valve, fmic, turbo technics actuator and a 2.5 inch system? hoping 280? anyone else running the same kind of setup? cheers in advance

[Paul]

pub figure 280, realistic 250. depends on rollers

[craig green]

280bhp @ fly is the right ballpark tbh.

Is the bottom end re-built at all, or as it left the factory all them years ago?

Nasty Bleed valve wont help with boost spiking however.

[ck]

yeah in the region of 270-280 at the fly.

remove your bleed valve if you want the engine to last lol. bloody things should never be made.

if setup correctly your chips will control your boost without the need for any bleed valves or the like

[R1CH]

Thats pretty much the same set up as i was running, mine made just over 300 @ the fly, if the engine is healthy enough then it should make 280 no probs.

[Adam]

Ditto the bleed valve comments!!
You dont need that, as the ecu/chipset controls the boost.......