GTE/GSi side skirt clip position..

[Pistol Pete]

As title. Wanting the measurements for the holes so i can drill and rivet my clips to my sills. Had a look in the articles section, thought there was a how to in ther, but no lol

*goes off to do a search* :roll: lol

[Shaun_O'Donnell]

Can you not just offer the skirts up with the clips attached, but with a little spot of grease over the hole to leave a witness mark on where to drill?

[Pistol Pete]

Yeah tried that, didnt quite mark the tape. Upon doing a search seems others had the same problem. Pack out the clip and mark it that way. I have some measurements. 3 cm between each hole and a diameter of 2.5mm. I may have a go at doing a how to. Doing a search, it seems its an often asked question.

[Andy]

I think the best answer for this would be if some one would be so kind to measure theirs on their gte/gsi's and post it up.

[Pistol Pete]

/\ +1.