View Full Version : x16xe plug
General Baxter
20-02-09, 03:09 PM
where the hell does this go ?
http://i11.photobucket.com/albums/a191/baxters83/cid_5aDQEeEstm.jpg
right engine starts for around a second then cuts out, then i have to wait for 5mins before i can try again, other wise it just cranks over,
its getting fuel and spark, and yes iv checked the earths
Looks like the rad fan?
Mine is running for five secs and cutting out, but once the ign is turned off and back on again it does the same,
Southie
20-02-09, 03:20 PM
Looks like the rad fan?
Mine is running for five secs and cutting out, but once the ign is turned off and back on again it does the same,
As above fan plug.
Is this becoming a common issue with the small xe engines. Mines the same :cry: Flash code check at the weekend for me. Fingers crossed it works.
I havnt flashed the codes out for the reason that i havnt wired up the ECU light lol
I havnt flashed the codes out for the reason that i havnt wired up the ECU light lol
you dont need to do what i done, put the wire from the ecu to the back of the dials
General Baxter
20-02-09, 04:16 PM
got the ecu light to work, no codes being flashed up :(
where about is the plug, is it near the servo? Ill have alook at mine when i know where abouts it is bud
As above fan plug.
Is this becoming a common issue with the small xe engines. Mines the same :cry: Flash code check at the weekend for me. Fingers crossed it works.
^^
Bigs it is the rad fan.
Oh a rad connetor from a corsa? they look wierd lol
Southie
20-02-09, 04:31 PM
got the ecu light to work, no codes being flashed up :(
Did you get the ignition key with the chip in? Sounds more like an immobiliser problem :confused:
if it was immobilisor the ecu light would flash and you wouldnt get a spark or any fuel
General Baxter
20-02-09, 05:21 PM
just rewired it, the ecu light dont even come on with igntion on, no codes flash, (no light) but the car still runs for a few seconds
must have it wired up wrong as im 99% sure it comes on with the ignition then goes off when its started
General Baxter
20-02-09, 05:24 PM
iv wired it up to your diagram from your hotmail
you checked the bulb???
and im sure you mean photobucket
General Baxter
20-02-09, 05:30 PM
yes bulb works fine,
just to check the wire connected to the bulb from the engine loom is that a live or an earth?
yes PB :)
its a live i think. trace which side of the bulb the wire goes to to work it out
General Baxter
20-02-09, 06:13 PM
**** this x16xe crap, its now a c16xe, wired in the loom fired straight up lol
The ecu EARTHS the bulb, its fed a live from the dash loom.
And its the SAI blower plug, nothing do with a rad fan!
The problem your having is as said over earlier on the phone, the immobiliser....
It will run for a few seconds until the fuel pressure in the rail has died, hence why it wont run again.
General Baxter
20-02-09, 07:06 PM
it runs lovely with the c16 stuff on it so meh lol
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.