nova bits

[16xe_chris]

I require the cowl that covers the clocks in a mk2 and the plastic part to the right that holds the light swith.

I also need the thin plastic part that covers the heater blower under the scuttle pannel.

[jord77]

i have the plastic part to cover the heater got both bits make me offer

thanks

[16xe_chris]

You have pm

[16xe_chris]

Up ttt again

I also need a mk2 connector the big one that goes into the clocks, must have a decent bit of wire on it so i can re-solder them back to my loom

[let_nova]

did you find the other protector?

[16xe_chris]

Not yet mate, my garage is that full of nova and work gear its a joke, need to start getting rid of some stuff

[xe Dan]

ive got one plastic cover make an offer

[16xe_chris]

Dan you have pm

[16xe_chris]

Bttt

[AlexW]

I have the bit that goes over the clocks on a mk2.

[16xe_chris]

you have pm

[raymond]

ive got both clock surround and heater cover pm me offer posted

[16xe_chris]

you have pm

[Ernie]

Up ttt again

I also need a mk2 connector the big one that goes into the clocks, must have a decent bit of wire on it so i can re-solder them back to my loom

If you push the little tabs down one at a time you can push in the ones from a mrk1 loom.
Just change them over one at a time then there is to need to soilder anything.
Ive done this to my old gte when i changed it to a gsi dash with gsi clocks.
Very easy to do just remember to push the tabs back out so they lockin when into the new mrk 2 plug.

[16xe_chris]

If you push the little tabs down one at a time you can push in the ones from a mrk1 loom.
Just change them over one at a time then there is to need to soilder anything.
Ive done this to my old gte when i changed it to a gsi dash with gsi clocks.
Very easy to do just remember to push the tabs back out so they lockin when into the new mrk 2 plug.

Cheers Ernie:thumb: I still need the plug though lol

[NOVANICK]

I require the cowl that covers the clocks in a mk2 and the plastic part to the right that holds the light swith.

I also need the thin plastic part that covers the heater blower under the scuttle pannel.

don't know what you already have but i've got these 3 parts. PM me

cheers

[16xe_chris]

you have pm!!!!!!!!!!!!!!!!

[NOVANICK]

Chris - just sent another PM! Cheers