dabsy
13-02-09, 10:50 PM
See my old WIP thread:-
http://www.pngclub.com/forum/showthread.php?t=80635
All parts below are unfitted and available for pick up now or postage (need to contact me for post costs).
1litre Nova life shell - J plate 92 - fully redtop converted - so engine bay all stich welded - Gartrac 8 point cage plates fully welded in and all interior seams stitch welded. Some of the cage tags installed ready for tapping, Spare wheel well removed and plated rear turrets stiched too. All interioir shell rust seen in thread pics sorted. Exterior panels straight some rust apearing the wings. Started preping the rear passenger arch, but ran out of time fixing. - Gone
Gartrac 8 point bolt in cage (no diag) with Homologation papers if it's important to you I can find it! All bolts/washers there and rear strut plates too. Door bars and front strut bars come with it. Also has tag points for a/b pillars, top of doors, above windscreen - Sold
Avo coilovers - full set - done about 50 miles since refurb last year at cost of circ £130 - threads a little rusty, but nothing some cleaning and grease won't sort out - SOLD
2 litre XE large bore 4 into 1 manifold used but no holes (2 1/4") includes lambda sensor also - £100
http://i185.photobucket.com/albums/x316/Dabsy_RR/DSCN1666.jpg
http://i185.photobucket.com/albums/x316/Dabsy_RR/DSCN1667.jpg
Power flow stainless single box system 2 1/4". Was 5" jap slash cut, but tail pipe removed to de chav and replace with single 2.5" chrome - SOLD
Quaife ATB for F20, unused since purchased. Bought from Oddball off Migweb. Complete with bearings, speedo washers? I think - low miles - sold
Eccentric aluminium front top mounts very little useage - sold
2 litre Astra Gsi brakes - calipers may need pistons working as been stood for a while, cross drilled discs done 3k mile, EBC green stuff pads, did the ring without too many probs - £50 the lot (will not split)
86,25mm used Accralite High Comp pistons inc gudgeon pins and clips , v. good condition - SOLD
Gte clocks 70k miles - SOLD
Various black dash surround trim parts - £10 lot
Gte master cylinder and servo - SOLD
headlamp switch trim with v good working switch - £10
2litre xe Motronic ECU with Grp N chip - £60
front strut top mount plates - unused - sold
Cav internal gear shifter with standard nova to convert to nova change mechanism - sold
GSXR 750/1000 K3 type individual throttle bodies - stripped down ready to build for xe conversion + spacers and some threaded bar to space them with - £75
c20xe engine inc inlet manifold/starter/full wiring loom/F20 box - £300
c20xe thick conversion shafts - sold
full set of 3 competition engine/gearbox mounts - SOLD
Engine front and rear Mount Kit For 2.0 XE Conversion (http://www.chrisastleymotorsport.com/product_info.php?cPath=22&products_id=35&osCsid=bmcq17oq8eq4hu2ctjlv11ekt4) (Chris Astley) - £20
http://i185.photobucket.com/albums/x316/Dabsy_RR/DSCN1689.jpg
Front strut brace bit rusty needs lick-o-paint - OMP not for 2l XE - Sold
Astra Gsi Fans in good condition (small amount of laquer peeling) need a clean though - set of 4 with Yoko A539's, loads of tread - like 5-6,5mm on all four - Sold
FSE power boost valve - fitted to my XE conversion - £10
SEE SECOND PAGE OF THIS THREAD FOR FURTHER PICS.
All panels available if not sold first with the shell
PM or reply to thread if you are interested. Bear with me on replies as there's a lot of interest and i've still a few parts to strip down.
Dave.
http://www.pngclub.com/forum/showthread.php?t=80635
All parts below are unfitted and available for pick up now or postage (need to contact me for post costs).
1litre Nova life shell - J plate 92 - fully redtop converted - so engine bay all stich welded - Gartrac 8 point cage plates fully welded in and all interior seams stitch welded. Some of the cage tags installed ready for tapping, Spare wheel well removed and plated rear turrets stiched too. All interioir shell rust seen in thread pics sorted. Exterior panels straight some rust apearing the wings. Started preping the rear passenger arch, but ran out of time fixing. - Gone
Gartrac 8 point bolt in cage (no diag) with Homologation papers if it's important to you I can find it! All bolts/washers there and rear strut plates too. Door bars and front strut bars come with it. Also has tag points for a/b pillars, top of doors, above windscreen - Sold
Avo coilovers - full set - done about 50 miles since refurb last year at cost of circ £130 - threads a little rusty, but nothing some cleaning and grease won't sort out - SOLD
2 litre XE large bore 4 into 1 manifold used but no holes (2 1/4") includes lambda sensor also - £100
http://i185.photobucket.com/albums/x316/Dabsy_RR/DSCN1666.jpg
http://i185.photobucket.com/albums/x316/Dabsy_RR/DSCN1667.jpg
Power flow stainless single box system 2 1/4". Was 5" jap slash cut, but tail pipe removed to de chav and replace with single 2.5" chrome - SOLD
Quaife ATB for F20, unused since purchased. Bought from Oddball off Migweb. Complete with bearings, speedo washers? I think - low miles - sold
Eccentric aluminium front top mounts very little useage - sold
2 litre Astra Gsi brakes - calipers may need pistons working as been stood for a while, cross drilled discs done 3k mile, EBC green stuff pads, did the ring without too many probs - £50 the lot (will not split)
86,25mm used Accralite High Comp pistons inc gudgeon pins and clips , v. good condition - SOLD
Gte clocks 70k miles - SOLD
Various black dash surround trim parts - £10 lot
Gte master cylinder and servo - SOLD
headlamp switch trim with v good working switch - £10
2litre xe Motronic ECU with Grp N chip - £60
front strut top mount plates - unused - sold
Cav internal gear shifter with standard nova to convert to nova change mechanism - sold
GSXR 750/1000 K3 type individual throttle bodies - stripped down ready to build for xe conversion + spacers and some threaded bar to space them with - £75
c20xe engine inc inlet manifold/starter/full wiring loom/F20 box - £300
c20xe thick conversion shafts - sold
full set of 3 competition engine/gearbox mounts - SOLD
Engine front and rear Mount Kit For 2.0 XE Conversion (http://www.chrisastleymotorsport.com/product_info.php?cPath=22&products_id=35&osCsid=bmcq17oq8eq4hu2ctjlv11ekt4) (Chris Astley) - £20
http://i185.photobucket.com/albums/x316/Dabsy_RR/DSCN1689.jpg
Front strut brace bit rusty needs lick-o-paint - OMP not for 2l XE - Sold
Astra Gsi Fans in good condition (small amount of laquer peeling) need a clean though - set of 4 with Yoko A539's, loads of tread - like 5-6,5mm on all four - Sold
FSE power boost valve - fitted to my XE conversion - £10
SEE SECOND PAGE OF THIS THREAD FOR FURTHER PICS.
All panels available if not sold first with the shell
PM or reply to thread if you are interested. Bear with me on replies as there's a lot of interest and i've still a few parts to strip down.
Dave.