undersealer

[torquey]

How easy is it to remove from the inside wheel arches, want to paint them red in hammerite.:thumb:

[meritlover]

its about as easy as picking chewing gum out of your pubes.

not a nice task. but made slightly easier with a heatgun and scraper.
you will have to cover the arches with stone chip before they are painted or it will last about a day before the paint is shotblasted off leaving your nice arches to rot and be reduced to natures lowest energy form.

have fun
Meritlover
xxx

[torquey]

Cheers mate didnt think it was going to be easy. will have a crack at one see how it goes.:thumb:

[Andy]

Its not easy but then its not hard,its just so sh1t and time consuming.A wire wheel on a drill is good aswell

[draper]

firestarter, toxic firestarter !!

[16xe_chris]

Its not easy but then its not hard,its just so sh1t and time consuming.A wire wheel on a drill is good aswell

Then it all turns into stringy goolol

Book a few days off and crack on :thumb: be prepared for sore thumbs and fingers lol

[Pistol Pete]

its about as easy as picking chewing gum out of your pubes.

not a nice task. but made slightly easier with a heatgun and scraper.
you will have to cover the arches with stone chip before they are painted or it will last about a day before the paint is shotblasted off leaving your nice arches to rot and be reduced to natures lowest energy form.

have fun
Meritlover
xxx

FPMSL

As said heat it up and try scraping it off. I just cleaned, primed and painted over it though.

[torquey]

will give it a go nice one all.

[boats 16v]

yer hard and messy sometimes to