Injection fueling ?

[hc coupe]

Hello,


http://i3.ebayimg.com/05/i/001/1c/3b/2cd3_1.JPG

(I want a similar set up to the above)

However this can only be used with a Carb engine?. What have other people done that hasn't cost the earth ?? Im running 135 bhp injection on TB's and I wanted it on show :roll: ... I already have the GSi pump but its looks like its on its last legs so I wanted to get a new one, then job done (don't have to worry about it again sort of thing)

Thank you if anyone can help (+rep)

Hc

[Welsh Dan]

You can get high pressure pumps, swirl pots and pressure regulators for injection setups. Check out Dars project log for pics, or the likes of tweeks, rally design to buy them.

[Adam]

You can run a swirl pot setup if you want.
Using a low pressure pump to feed the pot, and then a high pressure pump to feed the injection rail.

At 135hp though just a standard vauxhall pump setup on its own will be fine, seeing as thats all c20lets run as standard, at 200hp.....

[hc coupe]

So if i wanted to go do the route of a swirl pot setup, would I need to buy :

Low Pressure pump (http://www.rallydesign.co.uk/product_info.php?cPath=281_1885&products_id=13662) (I have know idea if thats a low pressure one?)

Swirl pot (http://www.rallydesign.co.uk/product_info.php?products_id=11750)

High pressure pump (http://www.rallydesign.co.uk/product_info.php?cPath=281_282&products_id=1698) (I have know idea again)

I guess after this I would need the correct unions and injection lines (braid or rubber?)

Sorry about my lack of knowledge

[Adam]

Thats it yep.
But thats not a high press pump.

For the high press pump, just use a standard vauxhall mpi pump.

And yeah, you'll then just need enough fuel pipe etc to fit the swirl pot.

Look in Dars/Trackdaynovas/Ernie's WIP threads for more info :)

Like so:
http://www.sbdev.co.uk/Info_sheets/Fuel_injection%20_Set_up_instructions/2.0L%20Taper%20instuctions%20Print%20All/Fuel%20system%20with%20swirl%20pot.htm