clutch

[torquey]

how hard is it to fit a clutch on a f16 box?:thumb:

[Asa-James]

if its got the inspection plate then not very. get a haynes and a clutch fitting kit, should take you no more than an hour...

[GRUNT 16V]

Piece Of P155 Takes About An Hour

[Paul]

piece of piss:

Tools needed 3 x 11mm spanner to remove flywheel cover, 4 x 10mm spanner/socket to remove inspection plate. 6x 10mm to removed clutch from flywheel, 1 x pry bar/long driver to get off the thrust bearing, 6ish x 10mm and 4 ish 13mm to remove end cover from gearbox.

1xMultispline (sorry cant remember size) and 1 pai of circlip pliers to remove input shaf. 1 x slide hammer and M7 bolt for removing the ino,reffiting is a reverse of removal.

[Welsh Dan]

1xMultispline (sorry cant remember size)

8mm, 12 sided :).

[Adam]

You are all assuming the engine has a flat fly/clutch..... lol

If Pot, box/engine out job.

[torquey]

Ok cheers will all will check what type it is.