View Full Version : clutch
torquey
10-02-09, 05:55 PM
how hard is it to fit a clutch on a f16 box?:thumb:
Asa-James
10-02-09, 10:14 PM
if its got the inspection plate then not very. get a haynes and a clutch fitting kit, should take you no more than an hour...
GRUNT 16V
10-02-09, 10:56 PM
Piece Of P155 Takes About An Hour
piece of piss:
Tools needed 3 x 11mm spanner to remove flywheel cover, 4 x 10mm spanner/socket to remove inspection plate. 6x 10mm to removed clutch from flywheel, 1 x pry bar/long driver to get off the thrust bearing, 6ish x 10mm and 4 ish 13mm to remove end cover from gearbox.
1xMultispline (sorry cant remember size) and 1 pai of circlip pliers to remove input shaf. 1 x slide hammer and M7 bolt for removing the ino,reffiting is a reverse of removal.
Welsh Dan
11-02-09, 08:06 AM
1xMultispline (sorry cant remember size)
8mm, 12 sided :).
You are all assuming the engine has a flat fly/clutch..... lol
If Pot, box/engine out job.
torquey
11-02-09, 05:28 PM
Ok cheers will all will check what type it is.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.