View Full Version : Cam And Carbs??
GRUNT 16V
04-02-09, 10:32 PM
Im Fitting A Ast2 Kent Cam To My 1.3 Sb Engine With A Vernier And Was Just Thinking , Would A 32/34 Dmtl Be Able To Feed Enough Fuel Or Would It Be Better Using Twin 40's
Thanks Grant
chimp007_uk
04-02-09, 10:51 PM
should be ok... I know people who road rally 1300's with a cam and can only run 2 chokes so have to runt hat carb. It will need rejetting.
jimbob-mcgrew
05-02-09, 02:06 AM
whoah, check chimpy out :D
chimp007_uk
05-02-09, 10:05 AM
whoah, check chimpy out :D
lol Whats wrong with that?
Yeah should be fine. I had the same spec in a vauxhall powered mini grasstracker & it went pretty well. :)
I almost garaunteeeeeee that the vernier will be set at the "stock" timing position.
chimp007_uk
05-02-09, 11:20 AM
I almost garaunteeeeeee that the vernier will be set at the "stock" timing position.
I was going to say that. It'll be either standard, or one tooth either side... ;)
GRUNT 16V
05-02-09, 01:31 PM
Thanks Chaps !!! Is It Worth Fitting The Vernier Pulley Then?????
imho no... but if you already own it then fit it.... if you are about to buy one then dont bother
Grant is that an engine for you?
GRUNT 16V
05-02-09, 03:00 PM
Yes Bud It Is For Myself!!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.