XE loom wiring help pwease

[Mazz]

I've got 3 XE looms out of which i intend to make into one good one!
The one i've decided on has a blue/red wire (circled red (which after looking at Simp's wiring thread (http://www.pngclub.com/forum/showthread.php?t=98133) is fuel pump) coming out near the ECU plug, but not connected - however i've found another blue/red wire joined into fuel pump relay plug (circled blue):

Where does the red circled blue/red go to?

http://img235.imageshack.us/img235/5585/cimg4004fn4.jpg (http://imageshack.us)

This is the plug:
http://img70.imageshack.us/img70/9228/cimg4005fp3.jpg (http://imageshack.us)


Is this green wire for the rev counter? :
http://img57.imageshack.us/img57/9800/cimg4001sf3.jpg (http://imageshack.us)

And this i'm assuming this blue wire is for coolant temp sensor? :
http://img57.imageshack.us/img57/7100/cimg3999bg1.jpg (http://imageshack.us)
Thanks..

[loggyboy]

I cant see pics at work sadly, but as i remember it - it should go - red blue from small connector/ecu to the relay (thin wire), then from relay to the fuel pump (slightly thicker wire).

Yes green is for revs and blue for coolant.


Edit - just seen pics on my mobile, the plug in the 2nd pic is for the relay.

What connector is the green wire close to, as that should be in the engine bay, and there is no signal for the revs from there, it comes direct from the ECU IIRC.

[Mazz]

Thanks loggyboy, the green wire is off the n/s of the injector part (opposite end to the ecu plug)
So the red/blue out of the plug on Simps legs goes the red/blue by the ECU circled red in my pic)?

http://img.photobucket.com/albums/v310/TheSimps/Nova/Nova%20LET%20Build/3Plugs.jpg

[ck]

all wires needed should all terminate through the loom in the same place. i.e the small connectors next to the ecu plug will have every wire needed. some looms will have a switched live and constant live coming from the loom in the engine bay side.

rev counter wire should be with the connectors as stated above.

you loom with the Green tacho wire coming out by the ignition module connector, this looks like it has been converted at some point to go nto a nova, as the original coils rev counter wire would be where most people mount the ignition module.

fuel pump relay should not be like that at all, the wire should go back into the loom with the other wires, then should come out in the same place as the others with the 2 small connectors (larger red/blue wire) (smaller is speed sensor wire)


if u need any help just ask as i know them pretty much on the back of my hand