My 35k Minter (ish) lol

[Dod]

Its a Class D so the ID isnt correct but it wont matter anyway as it needs to be imported anyway. Got it in a PX and it was dramatically clean for what it is. The bottom of the doors vere a bit bubbley and the cross member is a little poorly looking but its a great wee car all that aside!!

http://i3.photobucket.com/albums/y92/Dods1/Pic047.jpg
http://i3.photobucket.com/albums/y92/Dods1/Pic907.jpg
http://i3.photobucket.com/albums/y92/Dods1/Pic882.jpg
http://i3.photobucket.com/albums/y92/Dods1/Pic880.jpg

http://i3.photobucket.com/albums/y92/Dods1/Pic105.jpg
http://i3.photobucket.com/albums/y92/Dods1/PICT0129.jpg

Anyway, its not exactly a WIP, its ready for Painting at the minute so that has to be done over the next few months (I told the spray man to take his time as I need the room) so when it gets back there'll go a set of 15" irmscher wheels, Engleman Mirrors, a Mangex System, Koni Adjustables or even Coilys if I can get a set and a New from the Box C16SE set up. (easier than the small block XEs!)
http://i3.photobucket.com/albums/y92/Dods1/PICT0116.jpg
http://i3.photobucket.com/albums/y92/Dods1/PICT0132.jpg
http://i3.photobucket.com/albums/y92/Dods1/PICT0117.jpg
http://i3.photobucket.com/albums/y92/Dods1/PICT0118.jpg
http://i3.photobucket.com/albums/y92/Dods1/PICT0119.jpg
http://i3.photobucket.com/albums/y92/Dods1/PICT0134.jpg
http://i3.photobucket.com/albums/y92/Dods1/PICT0133.jpg
http://i3.photobucket.com/albums/y92/Dods1/PICT0122.jpg
http://i3.photobucket.com/albums/y92/Dods1/PICT0123.jpg

[krobinson]

You should sell that to me!

[Dod]

It came like this:
http://i3.photobucket.com/albums/y92/Dods1/Pic853.jpg
http://i3.photobucket.com/albums/y92/Dods1/Pic852.jpg
http://i3.photobucket.com/albums/y92/Dods1/Pic851.jpg
http://i3.photobucket.com/albums/y92/Dods1/Pic885.jpg
GTE wheels, Interior (spotless) and Tail Gate. These were all sold off and the wee car was given its Standard Mint interior and a Poverty Spec Tail Gate in the same Colour, the car was then fitted with the only spare set of wheels I had at the time which were 17" Kahn Reps, which were then thrown onto one of my Cavs and replaced with the other 17s. The front was never lowered however the rear was done by the previous owner. Theres a long road to go with the car but it'll be done eventually, so dont expect Daily Progress reports. lol

Feel free to have a look and make a few suggestions if you fancy it.

[Dod]

Next day you're at nothing, take a spin up and I'll give you a good look round her now its not burried anymore. lol