can the servo blanking plate be used on the right

[dan23]

when the servo is removed can a servo blanking plate found on the left (looking under bonnet) be used to blank the hole ?

[The Simps]

no.

http://img.photobucket.com/albums/v310/TheSimps/Nova/Nova%20Coupe%20Project/24-08-083.jpg

[jimbob-mcgrew]

could get a big ass rubber grommit for it ?, or alternatively weld a circular plate in the hole. or make your own blankin plate with studs pressed into it so u can bolt it in.

[craig green]

Piece of MDF & some no-more-nails.... a squirt of Satin Black later....

Pikey motorsport TM lol

[dan23]

thanks for that
i dont understand why both the holes are different though:tard:

[craig green]

Different pedal assembly entirely with the R/hand drive I should think.

[pul16v]

i got the plate off the back of the std mastercylinder/servo and plated he hole up in the middle of it and then used the std bolt holes to bolt it back on
i also thought te opposite side plate would fit but it didnt

phil

[AlexW]

I will be using the standard mount for the servo with a hole drilled through a welded plate similar to the above. Hole will be for Some of the wiring loom ;)