rear disk conversion help

[lee02]

i have a problem with my rear disk conversion fitted to my car due to the offset of the rear axle the passengers side wheel hits the arch but the drivers side is ok i was wondering if it is possible to get the spacer machined down a couple of mm

[_JH_]

unless I'm not reading this right, your conversion hasn't been done properly. If so, I'd find out what else is wrong before simply adjusting it to fit.

it shouldn't be 'offset' :eek:

[burgo]

its perfectly normal for the nova beam not to be central to the car. i wouldnt recommend thining the conversion plate at all as that will effect its strength. id rather trim the

[Asa-James]

its perfectly normal for the nova beam not to be central to the car. i wouldnt recommend thining the conversion plate at all as that will effect its strength. id rather trim the

informative, mr.burgo...lol

[burgo]

hmmm im sure i typed arch after that. very strange

[lee02]

i cant take any more off the arch the lip on the wheel sits on the arch the wheels are 7j btw

[burgo]

what offset are they