Bodywork.

[AlexW]

Got a few questions as at last my nova is going to be welded soon.

The rear panel is rotten and i was thinking of cutting it where it meets the floor. and just putting a bit of metal over the ends of the chassis and put loads of seam sealer on it.

I was undecided on the passenger side rear quarter, the arch has totaly rotten though. Ive brought a non-gen full quarter and a arch repair panel for inside (After seeing ade's WIP) I was temped to cut the quarter repair panel to make a oversized repair panel. But was unsure if it would be better to use the whole thing.

I need to replace the front cross member but i was wondering if it would be worth it to replace the slam panel at the same time, (Complete front panel) Its not rotten.

Thanks in advance.

[Paul]

the more new stuff you put in the better it will be.

remember thought to check how good the metal is where ti joins.

[brainsnova]

you can get the lower front valance and cross member as one it joins onto the front under the headlights. that way you dont need to change the top part :thumb: