Do i need to?

[novalicous]

Just picked up a set of GSI skirts (cheers RSTchris) and i was just wundering if i have to take the bump strips of to fit them

Cheers Craig

[Martin]

i think they fit

[Jack]

Nope, I'm sure I've seen cars fitted with both before...

[novalicous]

I quikly held the fin part up against the car and it just seemed a bit tight

[Benn]

Will be tight, dont thinkthey look wuite right tho.

[Martin]

onces its tightend up should be fine, craig please dont screw them on.. VXL still sell the clips

[sulphur]

There was a white LET on pistonheads that had strips and skirts fitted.
Here's a pic.

http://i464.photobucket.com/albums/rr3/rainingsulphur/538818-2.jpg

[novalicous]

That pics just made me decide to take the bump strips of i dont thing it looks rite with them on

and martin dont worry am going to buy sum clips or a big tube of tiger seal lol

[Martin]

That pics just made me decide to take the bump strips of i dont thing it looks rite with them on

and martin dont worry am going to buy sum clips or a big tube of tiger seal lol

Clips FTW, tiger seal is pap, it peeled of of my old one n it rusted

[ade]

the fit but you have to jiggle the top of the skirt over the bottom of the bump strip and tbh it looks a mess.

Lose the bump strip.

Defo dont use tiger seal - clips are easy to fit. Just draw a line 2cm from the top of the sill along the length of the car and then mark off the gaps where the clips go on the skirts - theyre evenly spread (I think 16cm iirc and 3cm split for the rivets).

Use a rivet gin to attach them NOT self tappers!