Urgent! digi dash problem!

[mikesri]

I've just purchased sum coloured inserts for my digi dash but am strugling to get the silver screws out of the back! Is there an easy way?

[locky]

R the silver screws the torx heads?, if so, u need a torx bit on ur screwdriver, if they r just tight, push down, and try and turn it out!
Ne more probs on ur digidash, giv me a shout, i came across lots of probs!

[Ric 16v]

did u get the colour inserts from dominic stratten ???? if so I got some and they look well good, as for the screws I used a junior hacksaw and cut a straight line so I could use a flat headed screwdriver to unscrew them (u will have 2 cut deep enough or the screwdriver wil keep slipping out) It's pretty easy after that, if u have any problems send me a PM as I had to do the same to get to the colourd plates !!!!! and remember BE CAREFUL when u get to the liquid crystals or u will get an air bubble if u handle it too much or bend it etc which u cannot remove, the middle one has silver metal on it and the two side ones are white u have 2 remove these to get to the coloured plates