View Full Version : Dash removal / refitting
Mike B GTE
11-09-08, 02:41 PM
im seriously considering sending my MK1 dash to SFS for flocking. how difficult is it to remove and refit? im a little worried about taking things apart that i wont be a ble to put back together!!
any advise?:confused:
craig green
11-09-08, 03:11 PM
Its been years since I messed about with a mk1 dash.
However,
Glovebox off
Steering wheel off
Clocks out
Stereo off (assuming)
Lower under shelf off
Release the ash tray & there are screw(s) in the upper edg
Release the heater controls (screws behind)
unclkip the heater cables
Undo the 2 screws at either end of the dash
It should come out.
Its all in the HAYNES Bible.
As above ^
Piece of pish. Taking any old car apart is in comparison to more modern stuff. Just make note of where you removed things from, take pics/note down If need be. I put the bolts back in where they were removed from if possible also.
Dont bother with any of that, get a hammer and smash it out, replace with mk2 dash :D
Powered by vBulletin® Version 4.2.5 Copyright © 2025 vBulletin Solutions, Inc. All rights reserved.