Laguna Spliter

[Adam Moran]

Right...... picked one up for a fiver but havent a feckin clue how to fit it!! I've offered it up and its way to long and looks like it needs to be bent a little. Whats your advice guys?

Cheers

AJ

[locky]

www.topbuzz.co.uk
There is a guide ti fitting splitters on there
If it is too long, offer it up, measure how mush gap u have, and then cut it from the middle
*note:- do not cut it all off 1 side as it'll b 2 short on 1 side,
mark the centre and half the gap, mark half the gap on eithe side, and chop a chunk out of each side
screw up the front.
U may have to cut chunks from the bottom to bend into shape(dunno, aint fitted a laguna splitter but fitted seat, same method used)
and screw it up.
Cut off wotever u have left on the sides and job dun!
(im not sure if thats very clear! use the link above for reference)
Good luck, HTH

[Nova1.6]

here u go mate

http://www.stuffing.freeserve.co.uk/nova/images/parts/splitter.jpg

[jim sri]

Didnt have to cut mine in the middle mate. i took bumpa off and then you can work on it easily. i think i got it dead centred, drilled pilot holes in&then self-tapper screws to hold it in place,then cut slits(several)on each corner of splitter so it follows the curves on ur bumper, then self tap in etc.then trim off the excess splitter from each end with neat cuts.