conerting to injection??

[simon@novaheaven]

can someone please tell me whats involved in gettin my carbed nova to be able to take and injection engine??

i know it needs the injection fuel tank and some different lines fitting to the car but is there any wiring or does anyone have any tips or advice to give on the subject??

Cheers
Simon

[Dicko]

drain tank as much as poss (i did this by runing it until it was pretty empty, then conected a piece of fuel tube from the fuel pump to a petrol can, then ran the car, by the time the carb was empty it had put the last bit of petrol inot the can)

ripf off fuel lines
remove exhaust system+backbox in 1 piece of possible
loosen/remove handbrake cable
undo 2*13mm nuts holding tank clamps on
remove the jubilee clip holding the filler tube on, then the vent hose
remove fuel tank
fit new tank
fit fuel pump (if running GTE/GSi setup) with tie-its, or drill self tapers.
fit 3/4' fuel hose from tank to rear pump.
fit metal fuel hosing in apropriate places joining with 1/2' fuel hose

[CP]

get an engine complete with all it loom and ECU - it saves a lot of aggro