View Full Version : Cast Iron manifold (8v)
Just the cast section im after please folk's. Local to the mids if possible too.
lol for what engine mike , haha
i think i have a spare 1.6 one but will need a couple of bolts drilling out
just vaux trev
01-09-08, 12:30 PM
i have a few spare but as above engine size??
chappers1.3
01-09-08, 02:27 PM
I got one 4 a 2ltr 8v.. and i have the downpipe section aswel if u need.
Welsh Dan
01-09-08, 04:52 PM
I've got 1.2 and 1.3 items available in Wrexham.
Doh lol 1600cc so an SR one should work too. If it has no Lamba hole then bonus, if it has no bolts to drill out then mega bonus (as this is why im after one!)
Welsh Dan
01-09-08, 05:29 PM
No lambda hole, no bolts to drill out.
No lambda hole, no bolts to drill out.
Just what i like to hear :D you going to Combe cheif? How much you after for it?
Welsh Dan
01-09-08, 07:22 PM
I'm not going to Combe. I'm looking for £20 as I've got some bits to go with it that are near worthless without it. I can meet you partway, say Oswestry or a little further, but not until thursday night.
I'm not going to Combe. I'm looking for £20 as I've got some bits to go with it that are near worthless without it. I can meet you partway, say Oswestry or a little further, but not until thursday night.
Hhhhhmmmm, give me a few days and ill get back to you, as its a long way to drive for a cast manifold (read as - let me check local scrappies first & ill get back to you chap) :thumb:
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.