PDA

View Full Version : Spax VSX kit, GSi handles, parcel shelf



Iain
22-08-08, 08:57 PM
Few bits I won't be needing anymore so might as well sell.

Sold - Spax VSX lowering kit - £80 - Uprated/shortened dampers and -40mm lowering springs. Had about a years use on my old Nova. A bit of surface rust but would look good again with a lick of new paint. Only downside is the top of the piston has been rounded off so if you were to remove the topmounts you'd need an impact gun air tool (see second picture) but they're fine to bolt on and use

(Pictures removed)

GSi door handles - £10 - Not bad condition, but some shallow scuffs along the bottoms (pictured)

http://iainel.co.uk/images/forums/ForSale/Handles1.JPG

http://iainel.co.uk/images/forums/ForSale/Handles2.JPG

Parcel shelf - £15 - Good condition

http://iainel.co.uk/images/forums/ForSale/Parcel1.JPG

Would prefer collection from/meet around Nottingham.

Iain
23-08-08, 05:25 PM
A few more bits.

Sold - Lowering springs - £35 or £20 a pair - I was sold these lowering springs as a 60mm drop but I cannot guarantee this. The fronts are FK and the rears are Jamex, both in good condition. Pictures show manufacturer stamps if anybody knows where to find out more information on them. I've just compared the rears to some -40mm springs I have and they're a few cm shorter so fairly sure they're -60s.

(Pictures removed)

Rear drivers side repair panel - £10 - Bought a year ago and since stored in a dry garage. No dents or rust from storage.

http://iainel.co.uk/images/forums/ForSale/Arch1.JPG

Iain
03-09-08, 04:10 PM
:)

PE4
03-09-08, 05:56 PM
How much for the springs to southampton mate?

Iain
03-09-08, 06:05 PM
PM'd you mate.