Changing control switch bulbs R.E blower not producing......

[locky]

Rite, the easiest wat i found to do this is:- (kev u could add this to the guides!)
Pull hard on the 3 nobs (sounds dody, i know!)
Undo the screws and u should have access to the bulbs.
Pull out the bulbs and replace

I came into a prob whers the bulb holder pushed up into the dash
This is how i the did it! :-
Take your instrument panel surround off with 4 torx bits
Undo the torx screws on the dash, above the nobs
You should then be able to see some of the nobs housings
Where the wires are attached, give it a pull and the bulb holder should come out
Then change bulb and but back into holder!

Also, the light swith lights up.
To change this:-
Bend the tip of 2 (plain) screwdrivers, 90 deg
Push the screwdrivers into the sides and force it out
Pull out the bulb and replace
HTH

[Manta Mad]

cheers for that - was wondering if the head light switch did light up - the bulb must be gone in mine.

[ade]

lol locky - bending 2 screw drivers to get at the light control housing!

I use 2 bent ring pulls from 2 cans of coke! Saved trashing screw drivers - works a treat.

Maybe I was luck mind...I know some can be stiff as fcuk

my variable headlight dip adjuster switch bulb ( :o ) keeps popping - given up trying to change it.