View Full Version : engine problem
philthepill_389
18-08-08, 11:41 AM
building up the Rev's hits about 4800 then shuts off straight to 0 in a blink of an eye back up and revving hard
any one suggestions
thanks
philthepill_389
18-08-08, 03:19 PM
c16se
craig green
18-08-08, 03:20 PM
Check your earths in & around the engine bay. good starting point)
Does the rev counter needle jump & go to zero when it happens?
philthepill_389
19-08-08, 10:58 AM
i was doing about 70mph private road 4th gear building up the revs hit 4800/5000 and the rev counter needle hit the 0 rpm for a split second hesitation back up to 5000 then pulled hard
philthepill_389
19-08-08, 12:55 PM
checked all wires earth straps etc all fine
novacabrio
19-08-08, 09:24 PM
did the ecu light come on? If so it may of recorded a fault
philthepill_389
20-08-08, 10:48 AM
no light nothing very strange plugs leads and a good service me thinks
thanks all
for the rev counter to drop off, it would mean the power went off for a second or two, check main loom wiring & earths, possibly ign switch is getting worn
Powered by vBulletin® Version 4.2.5 Copyright © 2025 vBulletin Solutions, Inc. All rights reserved.