View Full Version : nova gte manifold
novajulz
16-08-08, 05:27 PM
hi without sounding dull any ideas how i get the bolts off the manifold the ones underneath the top bolts in between the pipes is there any special tool as i have tried to get at them but no space
wobble bit adaptor and lots of time, patience and grazed knuckles. ring spanner's not a bad bet either. Personally I have a set of snap on sockets that have the wobble drive built in so they're a lot shorter than a socket with wobble drive attached, perfect for manifolds
novajulz
17-08-08, 05:02 PM
ok thanx looks like im in for some fun then grr
If its the inlet manifold, you need to get under the car for best results.
If its the exhaust manifold, and a 4-1 affair, you can actually get your arms in between the downpipes and use something like a 13mm ring spanner for them.
stuartyj21
18-08-08, 08:30 PM
^^^ second that mike, but its still a bugger of a job.. goodluck
Aye, a slim ring spanner is best
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.