Internal Brake Line Help Needed ASAP!

[elgan]

Ive got a hydraulic handbrake to fit and have a Bias box already fitted with copper lines.

I want to run my lines internally. would consider braided lines to keep things neat!

I have a single line to the rear which splits at the beam.

Which connectors will i need to run inside to the handbrake and back out again to the axle?

What lengths of hose will i need to do the job front and rear?

Where should i buy my hoses and fixings from?

Need to do it while the car is in pieces again, so be very gratefull for your help. thanks :thumb:

[nathan.]

It all depends on what size threads you have on the master cyl for the hyd handbrake as to what banjo's you need.

If i was you i'd ring someone like Burton Power or Rally design and explain what you need, they should be able to help.

As for lengths, use some wire and route out where you want the brake lines to run. Measure the wire and perhaps add a foot or two to be sure its right as they can always be shortened.

:thumb: