Help Needed Gauges

[novajulz]

since iv put gte clocks into my 1.2 i havnt got the fuel gauge, the temp or battery and no rev counter any ideas thanx

[jimbob-mcgrew]

did you just plug the block connector straight into the gte clocks ?

i think you might need the origional gte connector and do some re-arrangement of the wires.
theres a guide somewhere on here, will try find it for ya.

[jimbob-mcgrew]

hmm, well i thought there was a guide, can only find digi-dash and cav/calibra conversion guide in the guide section. poo.

[Courtnova16v]

Also need help on this one. My car is a 1.2 carb model and had no rev counter fitted.

[belly257]

Also need help on this one. My car is a 1.2 carb model and had no rev counter fitted.

what and just the rev counter not working? iirc if its an mk1 nova you have to run a wire from the coil to the back of the dials

[Courtnova16v]

Rev counter is now working. Just need oil presure, battery, temp maybe and ecu warning light.

[Asa-James]

oil pressure you need a two pin switch, battery and temp should work...

[Jack]

hmm, well i thought there was a guide, can only find digi-dash and cav/calibra conversion guide in the guide section. poo.
There is, its in my dash swap guide :p

Thats assuming you're putting Mk1 dials into a Mk2 though, or vice versa. Have a look anyway, it will pick out the wire colours and pin positions. Temp gauge should be on the original connector block.