PDA

View Full Version : F13 box onto a sri engine?


greg1.4
15-07-08, 09:59 PM
i have just built a 1400 sri engine up, but no gearbox for it..

i have found a F13 box local to me, so what else will i need to get to fit this onto my 1400 engine?

do i need a 1600 clutch/bellhousing/flywheel or anything?

I need to know asap, please help!:confused:

Thanks

Greg
Steve
15-07-08, 10:16 PM
I'm pretty sure that sri's came with an f13 from the factory so shouldnt be a problem fitting it.
greg1.4
15-07-08, 10:26 PM
my engine had an f10 on it before..
greg1.4
15-07-08, 10:29 PM
also will a 1400 spi starter fit my sri flywheel?
AlexW
15-07-08, 11:00 PM
F13 was standard and yes a spi starter should fit but check the teeth
mikey14sr
16-07-08, 10:09 AM
Bolts straight on, even with a 1.3 starter, that's what my SRi engine came like and ran like for a couple of years.
Dod
16-07-08, 11:13 AM
Yup everythings a straight swap. Just make sure its a CR F13 box.
rodgers
16-07-08, 02:17 PM
what do you need to look for on the box to see if its a cw before actualy using the box, like a stamp somwere?
Dod
16-07-08, 02:32 PM
CR. The ratios are stamped on the casting on the Box and its marked CR on the underside of the box at the passengerside if you're looking up from underneith.
rodgers
16-07-08, 02:37 PM
stamped the side nearest the bell housing?
Dod
16-07-08, 02:39 PM
No, between the Diff Plate and the End plate on the Casting.
Dod
16-07-08, 02:42 PM
http://i3.photobucket.com/albums/y92/Dods1/Pic081-1.jpg

On the casting in this circle.
rodgers
16-07-08, 02:46 PM
right, cheers mate
, im going to have a look now
mikey14sr
16-07-08, 06:01 PM
http://img.photobucket.com/albums/v689/mickyd79/boxcode.jpg